CRL 1/8" Stainless Steel Cable 36' Roll - CBL1836K

CRL Pre-Cut Stainless Steel Cable Kits are offered in four standard lengths to make the install go easy. Included with each kit; one pre-cut 1/8" (3 mm) diameter 1 x 19 Type 316 Stainless Steel Cable, one Cat. No. SWGST1 Swaging Stud factory installed on Cable, one Cat. No. TENRR1 Tensioning Receiver, and one Cat. No. PUL4SS Pull-Lock. Recommended maximum spacing between cables is 3" (76.2 mm) center-to-center. The 1 x 19 construction Cable is engineered to hold static loads without stretching, and is relatively stiff. The maximum cable run is 50' (15.2 m) and post spacing is not to exceed 42" (1.06 m) on center.
Four Pre-Cut Lengths, As Well As Custom Lengths Available
Factory Installed Swaging Stud
No Special Equipment Required for Installation
Test Reports Available